Engineering: generators

Print Page | Close Window

generators

Printed From: Jobships.com
Category: Maritime Knowledgebase
Forum Name: Engineering
Forum Discription: Topics related to Shipboard Machinery, equpment and process are discussed here.
URL: http://www.jobships.com/forum//forum_posts.asp?TID=298
Printed Date: 16 Nov 2024 at 3:56pm
Software Version: Web Wiz Forums 8.02 - http://www.webwizforums.com

Topic: generators

Posted By: somraj roychoudhury
Subject: generators
Date Posted: 24 Jul 2007 at 10:04pm

In my last ship my generator was dihatsu.
In the piston it was seen that there were two scraper rings,one below the gudgeon pin and the other just above the gudgeon pin,if this was so,then how was the compression rings above the scraper rings were getting lubricated?

Replies:

Posted By: PERI AVADHANI
Date Posted: 19 Oct 2007 at 7:05am

Hi,

The cylinder lubrication is carried out in this particular engine is by applying oil on the cylinder surface between the scrapper rings. By doing so using the small pores in the cast Iron liner holds the lub oil to lubricate the rubbing surface between the rings and the liner surface to reduce the friction. ( in the case of the Crome plated liner the honed surface does this work- and this is the function of the honning we do on the generators.)

Cylinder lubrication is not effective when the cylinder pressure is high or the combustion is being carried out.

Best Regards,

Posted By: ved prakash
Date Posted: 29 Jul 2010 at 6:13am

the upper scraper ring serves the purpose of spreading lube on the liner surface

and scraping the oil also.

this lubrication is valid for all loads and combustion conditions

as long as lube oil pressure is more than 3.5 kg